Rogre Grease Separator

Introduction

Rogre grease traps/separators are designed for underground fitment and installation into commercial premises producing wastewater containing fats, oils and grease. The Rogre require low maintenance and deliver long lasting performance making them an ideal choice to prevent damage to sewer pipes and wastewater treatment facilities.

Specification

Manufactured in accordance with EN 1825 Roto, grease separators are made from environmentally friendly material (polyethylene LLDPE). They are very durable, lightweight and resistant against various chemical substances used in the kitchen.

Rogre Size Range

Six models are available ranging from 1000 ltr to 7500 ltr: NG2, NG4, NG7, NG10, NG15 & NG20. All models have a large sealed lid allowing easy access for cleaning.

What size of grease trap do I need?

The size of grease trap is determined by number of meals or the maximum possible flow of contaminated water, type of pollution, effluent temperature and detergent use. You can calculate by the formula: NG = Qs * fd * ft * fr * fm

  • Qs = The amount of wastewater in l/s
  • fd = Density of grease (if it is greater or lesser than 0.94 g/cm3)
  • ft = Temperature factor (if higher than 50 °C, is increased)
  • fr = Detergents factor
  • fm = Increased grease factor

Installation

Underground grease separator should be located close to the building in areas where release of strong and aggressive odours will not pose a problem and where it is possible to access the separator with the disposal hose of the disposal truck. The inlet level must be located below the frost level. The grease separator has to be opened for emptying and cleaning and should be easily accessible for cleaning and maintenance.

Material

Manufactured in polyethylene, which is 100% recyclable and ribbed for reinforcement. Roto supply the Rogre rotomoulded tanks in one piece with a large opening for ease of cleaning. The tanks have one or two 600mm diameter plastic covers, depending on size, with a seal making them watertight. The Roto tank wall thickness ranges from 8-14mm to give the tank its stiffness.

Catalogues

Roto Water Catalogue


UK Contact

Daniel Smithers
Phone: +44 (0) 7880 603010
E-mail: sales@roto-group.co.uk
Skype: danny.smithers1

Address

Roto Group
Puconci 12, Puconci
9201 Puconci
Slovenia

Facebook     LinkedIn     YouTube